> >>MRS High pressure spring

Parts and seal HPA

Manufacturers

  • Payment Available

    Payment Available

Testimonials ( 109 )
(4,9/5)

Review By Aurelien Beauvois,
Aurelien Beauvois
Commande d'un Saiga 12 Tokyo Marui,pas de chargeurs supp sur le site... J'appel le shop et le ven ...
16-03-2024
Verified Purchase
Review By Emmanuel Perez,
Emmanuel Perez
Wow, première commande, une grosse commande de rations militaires. seulement 3 jours après ma comm ...
06-02-2024
Verified Purchase
Review By Stephane Bracke,
Stephane Bracke
Je recommande à 100% livraison rapide et colis hyper bien emballé rien service au top
02-02-2024
Verified Purchase
See all Reviews
MRS High pressure spring View larger

MRS High pressure spring

10000585

New product

Polarstar

Polarstar MRS High pressure spring

More details

40 Items

In Stock

No reward points for this product.


6,70 € tax incl.

Data sheet

Type Spring
Color Silver
Material Steel
Compatibility MRS
Brand compatibility Polarstar

More info

Looking to get a little more "ooph" out of your MRS regulator?

Well then you are in luck since this beefy spring will do just that.

Changing out the spring can be done in a matter of minutes and will safely increase the output of your regulator to ~200psi while still retaining the ability to operate at 40psi.

Although some pressure gains can also be accomplished by shimming the original spring, changing the spring is more beneficial than the typical shim method.

When a spring is shimmed, the whole pressure range shifts up so you lose your low end pressure range.

By simply changing the spring's rate, the regulator still has the ability to operate at 40psi.

Even though the high pressure spring will technically not allow the regulator to recharge quite as quickly at that low pressure in comparison to the standard spring, at conservative rates of fire it is not going to be noticeable.

Please note:

    Output pressure will vary depending on the output pressure of your HPA tank so an SLP will produce a slightly lower maximum pressure than a standard 850-900psi HPA tank.

    If your gauge has a maximum reading of 160psi on the dial, you will need to replace it with our 220psi gauge in order to use the regulator at higher pressure without damage to the gauge.

    Compatible with the MRS regulator only.
    Only intended for use with systems capable of operating above 145psi.

Reviews

No customer reviews for the moment.

Write a review

Array

Array

Accessories

30 other products in the same category:

Customers who bought this product also bought: