> >>High pressure Micro Regulator and UGS Spring

Parts and seal HPA

Manufacturers

  • Payment Available

    Payment Available

Testimonials ( 109 )
(4,9/5)

Review By Aurelien Beauvois,
Aurelien Beauvois
Commande d'un Saiga 12 Tokyo Marui,pas de chargeurs supp sur le site... J'appel le shop et le ven ...
16-03-2024
Verified Purchase
Review By Emmanuel Perez,
Emmanuel Perez
Wow, première commande, une grosse commande de rations militaires. seulement 3 jours après ma comm ...
06-02-2024
Verified Purchase
Review By Stephane Bracke,
Stephane Bracke
Je recommande à 100% livraison rapide et colis hyper bien emballé rien service au top
02-02-2024
Verified Purchase
See all Reviews
High pressure Micro Regulator and UGS Spring View larger

High pressure Micro Regulator and UGS Spring

10000692

New product

Polarstar

Polarstar High pressure Micro Regulator and UGS Spring

More details

53 Items

In Stock

No reward points for this product.


6,90 € tax incl.

Data sheet

Type Spring
Color Silver
Material Steel
Brand compatibility Polarstar

More info

Polarstar High Pressure spring.

The Compact Regulator High Pressure spring is compatible with both first and second generation Micro Regs as well as the UGS and CGS systems.

Changing out the spring can be done in a matter of minutes and will safely increase the output of your regulator to ~200psi while still retaining the ability to operate at 40psi.

Although some pressure gains can also be accomplished by shimming the original spring, changing the spring is more beneficial than the typical shim method.

When a spring is shimmed, the whole pressure range shifts up so you lose your low end pressure range.

By simply changing the spring's rate, the regulator still has the ability to operate at 40psi.

Even though the high pressure spring will technically not allow the regulator to recharge quite as quickly at that low pressure in comparison to the standard spring, at conservative rates of fire it is not going to be noticeable.

Please note:

Output pressure will vary depending on the output pressure of your HPA tank so an SLP will produce a slightly lower maximum pressure than a standard 850-900psi HPA tank.) 

In the case of first generation Micro Regs, if your gauge has a maximum reading of 160psi on the dial that you will need to replace it with our 220psi gauge in order to use the regulator at higher pressure without damage to the gauge.

Reviews

No customer reviews for the moment.

Write a review

Array

Array

Accessories

30 other products in the same category:

Customers who bought this product also bought: